WOODLAND STUMP CAKE
Martha's modern version of the traditional yule log cake, or buche de noel, calls for rolling and filling chiffon cake with chocolate-hazelnut cream, covering in chocolate "tree bark," and decorating with candied "mushrooms" and pistachio "moss."
Provided by Martha Stewart
Categories Food & Cooking Dessert & Treats Recipes Cake Recipes
Yield Makes one 11-to-12-inch cake
Number Of Ingredients 21
Steps:
- Chiffon Cake: Preheat oven to 350 degrees. Brush two rimmed baking sheets with butter. Line with parchment; butter parchment.
- In a large bowl, whisk together flour, 3/4 cup granulated sugar, baking powder, and salt. In another large bowl, whisk together oil, egg yolks, milk, and vanilla seeds. Whisk egg-yolk mixture into flour mixture.
- In the bowl of an electric mixer fitted with the whisk attachment, beat egg whites on high speed until frothy. Add cream of tartar and beat until soft peaks form. Gradually add remaining 3/4 cup granulated sugar, beating until stiff, glossy peaks form, about 5 minutes. Whisk one-third of egg-white mixture into batter. Gently but thoroughly fold in remaining egg-white mixture with a rubber spatula.
- Divide batter evenly between prepared sheets and spread to edges with a spatula. Bake until tops spring back when lightly touched, about 18 minutes. Dust two kitchen towels with confectioners' sugar. Invert one cake onto a towel; remove parchment. Dust with more confectioners' sugar. Starting at one short side, roll into a log, incorporating towel. Repeat with remaining cake. Let cool completely.
- White Modeling Chocolate: Stir together white chocolate and 3 tablespoons corn syrup until mixture has consistency of thick batter or very soft dough. If mixture is too thick, add remaining 1 tablespoon corn syrup. Pour mixture into center of a large piece of plastic wrap; use edges of plastic to gather into a disk. Wrap tightly and let stand until firm, about 1 hour or up to overnight. When ready to use, transfer to a surface dusted with confectioners' sugar; knead until smooth and pliable.
- Semisweet Modeling Chocolate: Stir together semisweet chocolate and corn syrup until mixture has consistency of thick batter or very soft dough. Pour mixture into center of a large piece of plastic wrap; use edges of plastic to gather into a disk. Wrap tightly and let stand until firm, about 1 hour or up to overnight. When ready to use, transfer to a surface dusted with cocoa; knead until smooth and pliable.
- Chocolate-Hazelnut Filling: In a small bowl, whisk together chocolate-hazelnut spread and 1/4 cup cream until thickened. In a large bowl, whisk together remaining 3 cups cream and confectioners' sugar until soft peaks form. Add chocolate mixture and continue whisking until stiff peaks form.
- Assembly: Unroll cooled cakes, remove kitchen towels, and reroll. Cut each cake crosswise into thirds. Unroll one piece of cake and spread with about 1 cup filling. Roll into a tight spiral and place, cut-side up, in center of a large serving platter. Unroll a second piece of cake, spread with another 1 cup filling, and wrap around perimeter of first piece. Repeat with remaining 4 pieces of cake. Spread remaining filling over top and sides of cake.
- Roll white modeling chocolate into a 1/4-inch-thick round, about 11 inches in diameter. Place on top of cake and fold overhanging edges down sides of cake. Lightly brush overhanging edges with water. Roll 1 1/2 cups semisweet modeling chocolate into a 6-by-8-inch rectangle. Use the handle of a wooden spoon to press a pattern crosswise on semisweet chocolate to resemble bark. Use a pizza wheel to cut a straight edge along one long side of semisweet chocolate. Affix bark to perimeter of cake, cut-side up, and gather bottom to resemble roots, placing small balls of semisweet chocolate in between bark and cake to create more dimension. Continue in this manner, working around sides of cake. Repeat process with remaining semisweet chocolate, then seam pieces of semisweet chocolate together by pinching and folding over each other to create a gnarled appearance.
- Using a paring knife, score lines onto surface of tree stump, radiating out from center, to resemble cracks. Use a soft bristled brush to dust white chocolate with cocoa. Mix a small amount of cocoa with water, one drop at a time, until it has consistency of thick paint. Dip the tip of a 2-inch-wide coarse brush into cocoa mixture; dry-brush tree rings onto surface of tree stump. Brush sides and roots of stump in some spots with corn syrup; sprinkle pistachios over brushed spots to create appearance of patches of moss. Place a few candy mushrooms on sides of cake. Decorated cake can be stored in refrigerator, covered, up to 1 day.
WINTER TREE STUMP CAKE
Provided by Buddy Valastro
Categories dessert
Time 1h30m
Yield 1 winter tree stump cake
Number Of Ingredients 14
Steps:
- For the tree stump cake: Put about 1/2 cup of the buttercream frosting into a bowl and dye it to look like the inside of a tree stump (a few drops of yellow and brown food dye). Spread a thin layer of the colored buttercream onto the top of your prepared 6-inch cake and smooth out into a flat layer. Using a cake comb in a clockwise motion, create concentric circles on the top of the cake to represent the rings of a tree.
- Dust the bench with cornstarch and roll out the dark chocolate modeling chocolate so it is approximately 1/2 inch taller than the height of your cake and at least 20 inches long. The modeling chocolate should be kept fairly thick, approximately 1/2-inch.
- Using the sculpting tools, start texturing the modeling chocolate with scrapes, lines, divets, etc.
- After it is textured, trim the bottom edge so that you have a straight line. Wrap the modeling chocolate around the outside of the iced cake.
- For the cardinal: Roll some of the red modeling chocolate into a ball a little larger than a golf ball. Rolling one end between two hands, taper the ball to a teardrop shape. The pointed end of the teardrop will be the head. Pinch the top of the head and pull backward to make the tuft of feathers on the cardinal's head. With a rolling pin, flatten the remaining red modeling chocolate to 1/8-to-1/4-inch thick. Cut out 3 teardrop shapes about 2 inches long using either a craft knife or a teardrop-shaped cookie cutter. These will be the wings and tail.
- Dampen one side of each wing with a drop of water and stick them to the sides of the body. Do the same with the tail and stick it to the back. Use a tool to add feather details to the wings and tail if desired.
- Using a rolling pin, roll out a small amount of black modeling chocolate to about 1/8-inch thick. Cut it into a diamond shape to make the black part of the cardinal's face. Dampen one side of the black chocolate and stick it to the face area of the cardinal. Use the dragees for eyes. (If you don't have dragees roll 2 small balls of black modeling chocolate with your hands to about 1/4-inch diameter. Stick them to the cardinal's head.)
- Using ivory modeling chocolate, make a teardrop shape about 1/2-inch long. Stick it to the cardinal between its eyes to form a beak. Use a sculpting tool or a butter knife to add the mouth detail to the beak.
- For the mouse: Choose a modeling chocolate color for your mouse - white, tan, grey, brown or a more fanciful color. Roll some of the mouse color modeling chocolate into 2 balls; 1 about the size of a golf ball, the other a little smaller. Dampen a small area of each ball with water and stick them together. These will form the head and body of the mouse. The larger ball is the body.
- Roll 2 balls of mouse color modeling chocolate about the size of peas and stick them to the front of the mouse's head. Roll a small tube, 1/4-to-1/2-inch long and lay it between and on top of the 2 small balls. This will be the nose part of the mouse's muzzle.
- Roll 2 tubes of the mouse color modeling chocolate about 1-inch long each for the mouse's forelegs. Attach them to the side of the body and head.
- Roll 2 small balls of the mouse color modeling chocolate about the size of grapes and partially flatten them. These will be the haunches of the mouse's back legs. Attach them to the rear of the body on either side.
- Make the mouse's 4 paws by rolling 4 balls out of pink modeling chocolate about 1/2-inch in diameter. Attach them to the ends of the forelegs and the front of the haunches. Use a sculpting tool or knife to add toe details to the paws.
- Roll a very small ball of pink modeling chocolate and apply it to the tip of the nose.
- Roll a "snake" of pink modeling chocolate between your hands for the tail and attach it to the mouse's behind.
- Using a rolling pin, flatten out some pink modeling chocolate and some mouse color modeling chocolate. Using a 3/4-inch cookie cutter, cut 2 circles of each color. Dampen the backs of each pink circle and attach them to the mouse colored chocolate circles. These will be the mouse's ears. Attach them to the mouse's head.
- Attach a very small piece of white or ivory modeling chocolate to the underside of the mouse's muzzle to make the protruding incisors.
- For the mouse's eyes, use the dragees. (If you don't have dragees roll 2 small balls of black modeling chocolate with your hands to about 1/4-inch diameter. Stick them to the mouse's head.)
- Add your sculptures to the cake.
- Use the extra buttercream to add a snow effect to the top of the trunk and the board or plate your cake is on. Accent the snow with some clear crystal sugar.
Are you curently on diet or you just want to control your food's nutritions, ingredients? We will help you find recipes by cooking method, nutrition, ingredients...
Check it out »
You'll also love